JetPort 5604 / 5604i
The First 4-port Redundant Serial Device Server

World's First RTTD Technology

RTTD, Redundant to the Device
JetPort 5604 series provide dual Ethernet ports. When the dual Ethernet ports are connected, only one path will be activated, this is known as Primary path. The un-activated path will be the Backup path. When the primary path is down, the backup path will recover Ethernet connection in less than 200ms.

Inter-connect RTTD with Super Ring
JetPort 5604 RTTD technology works well with JetNet 4000/5000 series Super Ring technology, which provides users complete redundant solution from network infrastructure to the serial devices.

Four Serial Interfaces Can Be Configured for Different Mode

JetPort 5604 series have four serial interfaces, and all of the interfaces can be configured with different serial interface types, such as RS232, RS422, 2-wire RS485 or 4-wire RS485. Each of the ports also can be configured with different service modes. You can configure serial port 1 to Virtual COM mode, serial port 2 to TCP server, serial port 3 to TCP client and serial port 4 to UDP mode. All of the serial ports have their own settings and can work well at the same time.

Up to 5 Simultaneous Connections

To JetPort series provide you up to 5 simultaneous Virtual COM, TCP Server, TCP Client, TCP Tunnel and UDP connections. All the services are developed over the TCP/IP protocol stacks. You can easily connect to the serial devices over Ethernet and plan your serial to Ethernet applications.

Windows Virtual COM

After installing JetPort Windows driver, the serial port on the JetPort can be accessed by the Windows as the virtual COM port. Users do not have to modify the existing program to upgrade the legacy serial communications into serial over IP application.

TCP/UDP Socket

You can also use TCP/UDP socket programs to control JetPort's serial port. JetPort can be configured as TCP Server, to listen to TCP connection request, or as TCP Client, to actively request TCP connection to send data, or as UDP mode for multiple destination transmission.

5V/TTL Digital Input and Digital Output

JetPort 5604 series provide four digital inputs and two digital outputs. It allows users to connect the termination units' 5V TTL digital input/output. JetPort Commander allows you to monitor the status of the DI and DO, and assign the value of 0 or 1 to DO. JetPort also provides one data port for user to program DI/O "get" and "set" commands figure on the right. The logic Low (Value=0) power voltage is 0-0.8V, 0.8V is the max value. The logic High (Value =1) power voltage is 2-5V, 2V is the min value. JetPort also opens one TCP socket port for DI/DO programming commands.

Easy-to-Use Windows Utility and Smart Wizards

Korenix JetPort Commander is known for its abundant features, user-friendly interface and smart setup wizards. Customer can browse the JetPorts, configure services, monitor devices and group setup.

The group setup wizard includes Virtual COM Wizard, Group Setup Wizard, Group Firmware Wizard, Serial Tunnel Wizard and Group IP Wizard.

Virtual COM Wizard: Three steps to configure all Virtual Com ports

Group Setup Wizard: Copy specific configurations from one to other devices

JetPort 5604 Appearance

JetPort 5604i Appearance