| |
Korenix Releases the JetCon 6300 series, new industrial smart Ethernet I/O converter!
|
Taipei, Taiwan, Sep., 2008 ---Korenix Releases the JetCon 6300 series, new industrial smart Ethernet I/O converter, The JetCon 6300 series converts I/O signal to Ethernet messages and is equipped with one Ethernet port and multiple channels of Digital Input or mixed multiple channels of Digital Input and Output. The JetCon 6300 series provides digital input, event counter modes, digital output and pulse output modes. The flexible local logic rules and the Peer to Peer function can support users to configure point to point, point to multiple points or multiple to one operation.
|
The JetCon 6300 series provides a Windows Utility, Web configuration and Industrial Modbus/TCP protocol for integration. JetCon 6300 is with existed HMI/SCADA. Also, the robust aluminum case has good heat dispersion and IP31 protection. With the JetCon 6300, users can easily perform status monitoring and control the remote I/O devices.
Ethernet Based Block I/O Converter
The JetCon 6300 series is a standalone Ethernet I/O converter. It supports Din-Rail vertical mounting, where users can easily install the JetCon 6300 in the control box and construct the cables with the limited space. The JetCon 6300 series supports multiple channels of Digital Input and Digital Output. The RJ-45 Ethernet port allows users to configure the settings and the system maintenance, to poll the information/status, and to monitor I/O status & program logic rules and alarm events over network.
Industrial Modbus/TCP Compatibility
The JetCon 6300 series supports Modbus/TCP protocol, which is the most common protocol in communicating between the industrial electronic devices over TCP/IP. Modbus/TCP is complied the binary encoding of data and TCP/IP’s error detection mechanism. Typical function codes are attached to the protocol addresses to identify the meanings of each tag. Modbus/TCP allows users to monitor and control the I/O status and settings for the connected devices. Thus, the HMI and SCADA applications can easily support users to integrate the JetCon devices.
|
Logic Condition&Go Rule
The JetCon 6350 supports simple logic rules, which allow users to activate the DO when the DI channels status changed. The logic rule is the typical IF and THEN mechanism, e.g., IF Condition_1 occurred (logic_Transmitter mode), THEN Action_1 activated (Logic_Receiver mode).
There are two logic modes, Logic_Transmitter or Logic_Receiver. The JetCon 6330 is a pure DI module. It supports Logic_Transmitter and monitorsthe DI status. The JetCon 6350 is a mixed DI/DO module, which can support both Transmitter and Receiver modes. It is also capable of monitoring DI and changes to the DO when receiving DI status changed events.
Peer to Peer Mode
The JetCon 6300 series supports the Peer to Peer communications over Ethernet. The JetCon 6330 and the JetCon 6350 can communicate directly without connecting to any host PC and extra applications.
The rules can be activated by users configuring through the JetCon 6300 utility.
One or multiple IP addresses can be configured in the Transmitter mode. The event changed messages will be updated to the Receiver, which decides how to activate the action. Under this mode, technicians can request less wiring and save more time to develop users’ programs. |
|
